1. Faucet is leaking water
- Phenomena:
Water continuously leaks from the faucet even when the water intake valve is closed.
- Reason:
The faucet may have been installed too tightly, causing it to be dislodged. Improper locking of joints can also cause leakage.
- How to fix:
Adjust the faucet lock and check the connection screw. If the screw is too tight, loosen it.
2. Rubber gasket is misaligned, not installed, or damaged/missing
- Phenomena:
Water is leaking from the filter cup of the machine, causing water to flow down to the tripod.
- Reason:
The rubber gasket may be misaligned or not properly installed. It can also be lost during installation or replacement of the filter element.
- How to fix:
Check if the rubber gasket is deformed, lost, or old. If any of these conditions are met, adjust or replace the gasket immediately.
3. Couplings between lead wire and filter system are loose
- Phenomena:
Leakage occurs at the joints between the conductor and the filter system.
- Reason:
Over time, the force of the joints between the wire and the filter system can cause them to loosen and result in water leakage.
- How to fix:
Re-tighten the joints. If the coupling is the wrong size or damaged, replace it.
4. The filter element is clogged with reduced rubber gasket elasticity
- Phenomena:
Water leaks under the tripod and the machine does not filter clean water.
- Reason:
When the filter element is blocked, water cannot escape while the filter pump is still working. The rubber gasket also loses elasticity over time, causing water leakage.
- How to fix:
Check and clean the filter element. It is recommended to periodically replace the water filter element.
5. Being bitten by an insect or animal
- Phenomena:
There is a leak in the water line.
- Reason:
This can be caused by being bitten or bumped when moving the machine, or due to excessive water pressure.
- How to fix:
If the bite is small, use a rubber band to wrap around the conductor. If the bite is severe or large, replace the lead wire with a new one.
6. The pump of the water purifier has a problem
- Phenomena:
The filter works weakly or there is a water leak at the pump part.
- Reason:
Over time, the rubber gasket of the water pump can lose elasticity, causing the machine to leak water.
- How to fix:
In this case, contact a pump repair and maintenance center for the best support.
Some notes on using a water purifier to avoid leaking water
- Do not let the inlet water pressure be too high or too low.
- Replace the filter element periodically according to the manufacturer’s recommendations.
- Regularly monitor and check the filter element and accessories.
- Get the support of a technician if you don’t have the expertise.
Hopefully, the information shared above will help you understand the cause and how to fix a water purifier leaking water. If you have any questions, feel free to leave a comment below!
