Washing machines are not flushing? The cause and how to fix it

When using a washing machine, many people have encountered the phenomenon that the washing machine refuses to drain. Below, Dien May GREEN will guide you to find out the cause and how to fix this problem.


1 Drain hose is blocked

Carefully check the washing machine's drain hose for blockages or kinks. Clogged pipes will prevent the machine from draining the water.

Solution: If there is, straighten the tube or replace it with another tube if it can't be fixed.

Ống xả nước bị tắc nghẽn

2 The lid does not close tightly

Many cases of the machine not draining water is because the door is not closed tightly. To explain, the lid of the washing machine is usually connected to a hidden switch in the machine to always ensure that the machine is closed tightly before rinsing and wringing clothes to ensure the safety of the user.

How to fix: Please check the lid carefully to see if it is stuck or closed tightly!

Nắp máy đóng không chặt

3 Belt (belt) broken, loose

When the washer belt fails, the machine will not be able to continue the washing program and will stay there. Therefore, the machine will not be able to drain the water out. Use a screwdriver to remove the washer back cover and check if the belt is not damaged.

How to fix: You can replace the belt by following these instructions:

Dây đai (curoa) bị đứt, lỏng

4 Check the lint filter

Lint, dirt and paper scraps after a machine wash process will accumulate on the lint filter of the machine, causing a blockage that prevents water from passing through when the pump sucks .

What is a washing machine lint filter bag? How to use it properly?

How to fix:

For front load washing machines, the lint filter is usually located in the drum of the machine. Meanwhile to check this part on the front washing machine, you open the front corner cover near the base of the machine to check the condition of the filter and conduct cleaning when necessary.

5 Check if the drain hose is qualified

In this case, turn off the machine, disconnect the power and check if the drain pipe is damaged or may be gnawed by a mouse.

In addition, the installation of the discharge pipe must be in accordance with the standards, which means that the pipe must not be bent, bent or twisted so as not to affect the washing machine's water discharge process.

Washing machine drains water continuously? The cause and how to fix it

You also must not install the drain pipe too high compared to the floor where the washing machine is located, this directly affects the water discharge process. Therefore, you need to pay attention to check and immediately adjust the installation position of the exhaust pipe so that the outlet part of the exhaust pipe is lower than the floor.

If you have done all of the above, but the washing machine is still not draining. Please contact reputable service and repair centers for support!

Detailed addresses of warranty centers you can refer to!