Easily Repairing a Damaged Network Cable

Fixing a Broken Network Cable: Step-by-Step Guide

1Prepare the Tools

Before you begin fixing a broken network cable, make sure you have the following tools handy:

• A cable tie, preferably one used for tying electrical wires. You can easily find this type of wire in electronic stores.
• A replacement cable head in case the existing one needs to be replaced.
• A paper cutter to trim the cable.

2Steps to Fix a Broken Network Cable

Follow these steps to fix a broken network cable:

• Step 1: Use a cable tie to attach it to the network cable’s head, positioning it at the latch. Ensure that the width of the cable head matches the width of the latch. The wire’s wider end should measure about 4.3 mm.
• Step 2: Cut the excess wire using scissors or wire cutters, leaving about 4.5 cm.

• Step 3: Use a paper cutter to trim the thick end of the wire, ensuring it matches the latch’s dimensions. Take care to perform this step slowly and gently, testing the fit as you go.
• Step 4: Fold the cable segment into three parts.

• Step 5: Take a second piece of wire and tie it to the first piece on the network cable.

• Step 6: Fold the cable head down and plug it into the machine. When removing the network cable, press and hold the cable.

3Tips to Prevent Broken Latches on Network Cables

To avoid broken latches on network cables, consider these essential tips:

• Avoid sharp bends or rubbing against walls: Excessive rubbing causes damage to the cable, which could lead to broken latches. If your cable encounters this issue, wrap it with a shiny nylon tape to protect it from friction.
• Avoid exposing the cable to direct sunlight: If possible, install the cable in a cool location. If you have to place it outdoors, use a plastic tube to protect it from rain and sunlight, minimizing damage.

We hope this article helps you fix broken network cables quickly. If you have any further questions, please leave a comment below!