**Use Salt, Baking Soda, and Boiling Water**
With just these simple ingredients, you can make your old mop heads look brand new.
Start by mixing 3 tablespoons of salt, 2 tablespoons of baking soda, a few drops of dish soap, and 500ml of boiling water in a bucket. Stir the solution until everything is dissolved.
Salt is great for removing bacteria from your mop heads. Baking soda and dish soap act as powerful cleaners, helping to lift away stubborn dirt and grime. You can easily find baking soda at your local supermarket or baking supply store.
Soak your mop heads in the solution for about 10 minutes. When the water turns dark, remove the mop heads, squeeze out the excess liquid, and rinse them with clean water.
With these simple steps, your mop heads will be as good as new.
Regularly use this method to keep your mop heads clean and hygienic.
**Vinegar to the Rescue**
Create a powerful cleaning solution by mixing vinegar and water in a 1:1 ratio. Soak your mop heads in this solution overnight. In the morning, simply wash them with soap and clean water. The acetic acid in vinegar helps to soften dirt, eliminate odors, and disinfect your mop heads.
**Bleach and Dish Soap to the Rescue**
Start by giving your mop heads a quick clean to remove any loose dirt.
Mix bleach, dish soap, and water, then soak your mop heads in this solution. Leave them overnight. In the morning, remove the mop heads, rinse them thoroughly with clean water, and squeeze out the excess moisture before hanging them to dry.
**Hot Water and Dish Soap**
For this method, you’ll need a deep bucket, a pair of rubber gloves, dish soap, hot water (not scalding), and optionally, some bleach for extra cleaning power.
Wear your rubber gloves to protect your hands from the hot water and chemicals.
Dip your mop heads into the bucket, and use your hands to work the soapy water through the fibers. The water temperature should be comfortable for hand washing – not too hot!
Dump the dirty water, and refill the bucket with hot water, adding soap and bleach this time. Make sure the mop heads are fully submerged. Work the solution through the fibers, then let them soak for a few hours or overnight.
Finally, remove the mop heads, rinse them thoroughly with clean water, and hang them to dry.
After each use, be sure to wash your mop heads, squeeze out the excess water, and store them in a well-ventilated area to prevent mold and odors.
Source: Khoevadep