3 crucial tips for efficient and cost-effective air conditioning installation

There is a mistake in defrosting meat that many homemakers make, and scientific experiments have shown that this mistake increases bacteria by 15 times.

0
202

Don’t forget about the prime positions in the room to install air conditioners. You will be surprised when the electricity bill decreases significantly, and your health also improves compared to conventional installation methods.

When installing air conditioners, do not overlook the useful advice in the article. Installing air conditioners not only ensures aesthetic factors but also brings many benefits to health as well as reduces financial costs.

1. Note the position of the indoor unit

The position of the indoor unit will determine the distribution of cold air from the air conditioner throughout the room. Therefore, when choosing the installation position, you should choose a point where the air from the air conditioner can create air circulation for the room. Avoid areas with many furniture that can obstruct the wind and cold air streams. The indoor unit should be installed at a height of 2.5 – 3 meters above the floor is the best.

Newly built houses often have holes for air conditioner installation. However, if you change the layout of furniture in the room, you can actively choose a ventilated and suitable position for the indoor unit. If you still keep the original position, the hole should have a diameter of about 50mm and be at least 30cm away from the ceiling.

3 notes you can't miss when installing air conditioners for both cooling and saving electricity-1
3 notes you can't miss when installing air conditioners for both cooling and saving electricity-2

Place the machine’s center point 28 – 35cm away from the hole and let the hole slope outwards to prevent rainwater from outside flowing back in and damaging or causing mold in the air conditioner. The waiting electrical wires should also be neatly arranged to avoid a messy room. You can choose a power cord with a cross-section of 4mm. For cases where the pipes are buried in the wall when building a new house, you can choose pipes with a diameter of 6.1 – 7.1cm. After burying, both ends of the pipes should be sealed.

In addition, when installing the indoor unit, you should choose a position that is easy to clean, repair, and maintain at home for convenience. Avoid installing in a position above or near expensive electronic devices that can cause signal interference.

2. Note when installing the outdoor unit

The outdoor unit is installed outside to blow out hot air. Therefore, the installation position of the outdoor unit is extremely important, affecting both the efficiency of use and the aesthetics of the house. The position of the outdoor unit should also ensure safety for users when they need to clean, maintain, or repair it.

The position of the outdoor unit should have a height difference with the indoor unit to improve the operating efficiency of the air conditioner.

3 notes you can't miss when installing air conditioners for both cooling and saving electricity-3

The outdoor unit should be placed in a well-ventilated position for easy heat dissipation because the lower the temperature in the area of the outdoor unit, the higher the machine’s efficiency will be.

The outdoor unit should be located in a position that is easy to maintain, repair, and at the same time, not be completely covered to ensure the best heat dissipation.

3. Note the drain position

The drain position is of utmost importance but not everyone pays attention to it. When the air is cooled at the indoor unit, the steam condenses and liquefies, so there needs to be a drain pipe to ensure that it does not seep into the wall or fall onto the floor.

3 notes you can't miss when installing air conditioners for both cooling and saving electricity-4
3 notes you can't miss when installing air conditioners for both cooling and saving electricity-5

The installation position of the air conditioner always needs to consider the drain pipe. The pipe should be installed at an angle so that the water can effectively drain from the indoor unit. Since the drained water is cold, the pipe should be covered with insulation to prevent condensation that can cause mold on the wall.

According to toquoc.vn

You may also like

How to Reduce Wet Clothes Drying Time and Eliminate Musty Odors

Damp laundry can be a headache to deal with, but with these helpful tips you can manage wet clothes with ease. Read on to find out how you can make fluffing and drying your garments as worry-free as possible.

Benefits of Installing an Exhaust Fan for Air-Conditioned Rooms

Are you wondering whether to install exhaust fans in air-conditioned rooms? Check out the article below from Dien May XANH for all the answers you need!

5 Quick Fixes for Resolving Refrigerator Problems

Are you dealing with a problematic refrigerator? This article offers helpful solutions to 5 of the most frequent issues people face when using this essential appliance.

“Strategies for Lowering Electricity Usage When Using Air Conditioners and Air Coolers in Hot Weather”

With the hot summer months on the horizon, many of us are anticipating the need to use our air conditioners more frequently. However, with the extra use comes a higher electricity bill. XANH Electronics has the perfect solution – 10 helpful tips that will ensure you are using your AC more efficiently, and keeping costs down in the process!

Tips for Extending the Lifespan of Home Appliances for Housewives

Don’t let your household items wear out too fast! Read on to discover helpful tips and tricks for prolonging the lifespan of your possessions.