Laundry is always one of the most time-consuming and labor-intensive tasks for housewives, not to mention the fact that the steam iron can get dirty over time, with stains on the soleplate and dirt in the steam vents, which can cause yellowing on clothes and make your life more troublesome.
In some cases, while ironing clothes, you may accidentally let the iron come into contact with burning fabric, leaving black marks on the surface. Later, when using the iron again, you will find it difficult to iron clothes and sometimes the iron may become unusable.
However, with just a very simple and extremely lightweight step below, you can restore your old iron to its original condition in no time:
Use fresh lemon
Cut a lemon in half and use one half to rub vigorously on the burn mark on the iron soleplate.
After 2 – 3 minutes, use a clean cloth to wipe it off, and the fresh lemon will make the iron surface clean as if it hadn’t been burned.
Toothpaste
Apply toothpaste to stains or rust spots and use a damp cloth to rub on the mark. Rub it until the stain and residue are completely removed, then apply a thin layer of toothpaste to the entire iron surface and rub it again to clean the iron completely. After that, use a damp cloth to wipe the iron until the toothpaste is removed.
Salt
Pour a little salt onto a cotton cloth. Then, turn on the iron to the highest temperature and run it over the layer of salt on the cloth. The dirt and black marks stuck on the iron will quickly disappear as they continuously rub against the salt. Wipe off any remaining salt on the iron. Your iron will definitely become shiny again.
Use candle wax
Candle wax, when melted, will take away stubborn stains like burned fabric. Therefore, using candle wax is an effective way to clean an iron that has been stained by burning fabric.
First of all, plug in the iron and adjust it to medium heat. When the iron is hot, rub the candle wax on the burned area. Just keep rubbing until the candle wax melts and takes away the toughest stains. After removing the burn mark, use a dry cloth to wipe off any remaining wax on the iron surface.
Use vinegar and salt
Pour an equal amount of vinegar and salt into a pot and heat it on the stove until the salt dissolves. When the vinegar is warm but not hot, turn off the stove. Wait for the solution to cool down until it is warm but not hot, and then you can start using the solution to clean the iron soleplate.
Wear gloves and dip a sponge into the solution, scrub the iron surface clean.
Then, use a soft and thick brush to scrub away any burn marks. Do not use abrasive cleaning pads as they can scratch the iron surface.
Finally, use a soft cloth to wipe it again with a little vinegar, wait for the iron to dry, plug it in, and use it as normal.
According to Giadinh.net