The Ultimate Guide to Fixing a Slow Flushing Toilet: Unblocking the Drain Like a Pro

A slow-flushing toilet is a common issue, and it’s challenging to avoid this problem. Instead of calling a plumber, try the following methods to fix a slow-flushing toilet effectively.

1

You can purchase drain-clearing powder from supermarkets. Cut the corner of the bag, pour the powder into the clogged toilet, and then add 200ml of water, or you can dissolve it before pouring it into the toilet. After 3-4 hours, flush the toilet vigorously to clear the blockage. That’s it!

For further reference:

2

First, flush the toilet and insert the plunger into the drain hole, creating a tight seal. Then, use force to push the plunger down, pump it a few times to build pressure, and finally lift it decisively. Flush the toilet after each attempt. Soaking the plunger in warm water before use will make it softer and easier to work with.

3

Using dish soap is another effective method to clear a blocked toilet. The principle behind this method is to utilize the slippery nature of dish soap to help dislodge the blockage.

Preparation:

– Dish soap

– Hot water

Instructions:

Step 1: Pour dish soap directly into the toilet bowl and let it sit for 25-30 minutes.

Step 2: Pour hot water into the toilet bowl. The pressure of the hot water, combined with the slippery dish soap, will help dislodge and push down the blockage.

4

A roll of wide adhesive tape is all you need to clear a blocked or slow-flushing toilet.

Instructions:

Step 1: Use the tape to completely seal the toilet bowl’s opening, ensuring no gaps are left, as this will reduce the effectiveness of this method.

Step 2: Flush the water from the toilet tank into the bowl. The trapped air will push against the tape, causing it to bulge.

Step 3: Push the bulging tape down forcefully. This action will create pressure that will dislodge the blockage and push it down into the septic tank.

Step 4: Repeat steps 2 and 3 until the toilet is completely unblocked.

5 Using Coca-Cola to Unclog a Toilet

Coca-Cola’s ingredients can help loosen dirt and grime buildup in the toilet bowl and pipes. It can be used to clean the toilet and clear blockages.

Preparation:

– 1 to 1.5 liters of Coca-Cola

– 1 toilet brush

Instructions:

Step 1: Pour Coca-Cola directly into the toilet bowl.

Step 2: Wait for about 10 minutes to allow the Coca-Cola to dissolve and loosen the dirt. Then, flush the toilet to rinse it away.

6 Using Baking Soda, Vinegar, and Hot Water

This method is highly effective if the slow-flushing toilet is due to an excessive amount of toilet paper being flushed.

Preparation:

– Hot water

– 1 bowl of baking soda

– 2 bowls of vinegar

Instructions:

Step 1: Pour baking soda and then vinegar into the toilet bowl. The two substances will react chemically, breaking down any obstructions in the pipes.

Step 2: Pour hot water directly into the center of the toilet bowl, not onto the sides, as this will reduce the force and impact of the method.

Step 3: Let the mixture sit overnight, and flush the toilet the next day to find the blockage cleared and the slow-flushing issue resolved.

Try these additional simple methods that you can easily perform at home.

The above methods provide effective solutions for dealing with a slow-flushing or blocked toilet. We hope that these tips help you resolve the issue completely. Don’t forget to bookmark this page for future reference! Good luck!

Be sure to check out more handy tips at Lifehack.org.