Choose the Air Conditioner Installation Location
To distribute the cool air from the air conditioner evenly throughout the room, you need to choose the most suitable location to install the indoor unit, ensuring that it is not obstructed by furniture. The indoor unit is usually installed at a height of about 3m from the floor.
For new houses that want to pre-install air conditioning, it is recommended to have a hole with a diameter of about 50mm and at least 30cm from the ceiling. Place the hole about 28 – 35cm to the right of the center of the unit (for units with 9,000 – 12,000 BTU capacity). It is best to have the hole slanting outward to prevent rainwater from flowing back into the house. The power cord should be placed next to the hole for convenience and aesthetics. Choose a power cord with a cross-sectional area of 4mm. In the case of burying the pipes in the wall during new house construction, pipes with a diameter of about 6.1 – 7.1mm should be chosen, and remember to seal both ends of the pipes.
When installing the indoor unit, you should also consider for easy cleaning, repair, and maintenance of the air conditioner at home. Avoid installing the indoor unit above or near expensive electronic devices or devices that may interfere with the control signal.
Choose the Outdoor Unit Installation Location
While the indoor unit is installed indoors, the outdoor unit is installed outside the room to exhaust hot air. Choosing the installation location for the outdoor unit is not easy because the location of the outdoor unit affects the efficiency of the air conditioner and the aesthetic aspect of the house. It also determines whether it supports well for cleaning, maintenance, and repair of the air conditioner in case of any malfunctions.
In reality, many people face many difficulties when choosing the location to install the outdoor unit due to lack of careful calculation. When installing the outdoor unit, you need to consider choosing a suitable location so that:
The installation location of the outdoor unit must ensure that the distance and height difference between the outdoor unit and the indoor unit are within the allowable limits to improve the efficiency of the air conditioner.
The outdoor unit needs to be located in a well-ventilated position for better heat dissipation, as the lower the ambient temperature in the outdoor unit area, the higher the machine’s efficiency.
The outdoor unit should be placed in a position that is easy to maintain, repair, and should not be completely covered to ensure the best heat dissipation.
Selecting the Drainage Location
Due to the lack of knowledge about air conditioners, many people do not pay much attention to the issue of drainage for these cooling and heating devices.
When the air is cooled at the indoor unit, the moisture condenses and liquefies at the indoor unit. Therefore, a drainage pipe is needed to ensure that the water does not seep into the wall or fall onto the floor.
An efficient air conditioner installation location must ensure that the drainage pipe is installed at an angle so that the water can drain effectively from the indoor unit. If the drainage pipe location is not planned in advance, it will be difficult to install and affect the drainage as well as the aesthetics of the house. Since the water drained from the air conditioner is cold water, the drainage pipe should be insulated to prevent condensation and avoid causing mold on the walls of the house.
According to thoidaiplus